Page 1 of 1
Best way to enlarge swingarm bolt bushings
Posted: December 9th, 2007, 9:30 am
by alexh
What's the best way to enlarge the swingarm bolt bushings if you don't have a mill? It would be for an '87.
EDIT: I'm a tard and didn't see the thread below this one on the same subject, just disregard this.
Re: Best way to enlarge swingarm bolt bushings
Posted: December 9th, 2007, 9:58 am
by britincali
alexh wrote:What's the best way to enlarge the swingarm bolt bushings if you don't have a mill? It would be for an '87.
Why?
Posted: December 9th, 2007, 9:59 am
by alexh
Kicking around the aluminum frame idea again...
Posted: December 9th, 2007, 10:06 am
by britincali
If you go find a machinist they will make you a pair for $50-$100.
I thought you were asking about the bushings inside the swingarm, but you need case bushings
