Page 1 of 1
Handlebar suggestions?
Posted: May 4th, 2015, 7:43 am
by snakedriver
Hello folks, I'm a new member with an '87 CR500. My bike has bent bars, and I need a new set. I'm a novice rider, 72" tall and 190lbs. Does anyone have a recommendation for bars that work well with my bike? Thanks!
CR high bend
Posted: May 8th, 2015, 6:41 pm
by GB1073
I run CR high bend Sunline bars on my CR500 AFC, I had CR high bend Rentahl bars on my 95 CR500 before converting it into the AFC.
Posted: May 10th, 2015, 8:42 am
by TYSTYX
I use Tag's in the CR high bend on my 99.
Posted: May 11th, 2015, 1:48 pm
by Rhino89523
I have been using Tusk ATV bars on my bike and have 2 sets of oversize Renthal CR highs I'd sell. $10 plus shipping.
Posted: November 13th, 2015, 7:38 pm
by xcrider633
fasst flexx bar well worth the money!!!
Posted: November 16th, 2015, 12:28 pm
by Kuma
I'd pick up a set of $10 CR high bars from Rhino, figure out what you like, higher, lower or just right before spending $400 on a set of flex bars, I've heard good things about them but personally, I'd rather not even try them and find that I can't live without. that's what happened with a steering dampener, well worth the money!
Posted: November 16th, 2015, 4:14 pm
by cowboyona426
I'm a fan of the Windham bend myself, which are a little taller and a little straighter than the CR high.
Posted: November 16th, 2015, 6:48 pm
by Roostius_Maximus
I also have the windham rm/mid, not liking them, I'm going to go down to the pro taper's "woods low".
Posted: November 17th, 2015, 7:34 am
by cowboyona426
Roostius_Maximus wrote:I also have the windham rm/mid, not liking them, I'm going to go down to the pro taper's "woods low".
Are you interested in parting with those Windham bend bars?