Help!!!!

All Engine, Clutch, Chains, and Sprockets Stuff Here.
Post Reply
User avatar
freeride588
Posts: 418
Joined: November 20th, 2010, 3:51 pm
Location: San Diego

Help!!!!

Post by freeride588 »

Ok so my bike is having some issues.

The crank seal was bad and sucked tranny fluid. I replaced the seal and went through the bike just to make sure. Carb good and jetting was good before this. Reeds look good. New pipe and silencer. Air filter clean. After outting it back together it started right up and was smoking alot. So it continued to heavily smoke and runs but sputters and wont rev out. Let me know what you guys think im at a loss here. Thank you.
Kevin
Top
User avatar
Tharrell
Posts: 1670
Joined: January 27th, 2010, 11:03 am
Location: Mount Airy, NC

Post by Tharrell »

Sounds ironically like a bad crank seal :shock:
Top
OUTKAST INC.
Posts: 117
Joined: February 15th, 2009, 3:10 pm

Post by OUTKAST INC. »

or bad center gasket
Top
User avatar
2strokeforever
Posts: 1524
Joined: November 13th, 2009, 1:04 pm
Location: Vernon B.C Canada

Post by 2strokeforever »

replace the float, unless you just did it, if that dosent fix it it needed to be replaced anyways
the 450 will have less power and will be harder to start, and will be heavier, but to make up for it it will require more maintenance.
4stroke=dead fish
Top
User avatar
freeride588
Posts: 418
Joined: November 20th, 2010, 3:51 pm
Location: San Diego

Post by freeride588 »

2strokeforever wrote:replace the float, unless you just did it, if that dosent fix it it needed to be replaced anyways
Carb is new and i checked the float. Good idea though.

Turned out there was just alot of tranny fluid in the crank that needed to be burned out. Ran it for awhile changed the plug and its good.
Kevin
Top
Post Reply

Return to “Drive Tech”