Page 1 of 1
Gen 1 conversion bushing spacers and motor mounts
Posted: June 7th, 2013, 6:03 am
by davidonmars
Just picked up a gen 1 and want to do the conversion. motor will be a 93 I read somewhere but cant recall where that there is a honda bushing and spacer that is the correct size and I dont have to mess around with washers or anything? Anyone confirm this for me or have some part numbers. Also does andyone have a set of motor mounts kicking around. Thanks
Posted: June 7th, 2013, 2:34 pm
by hoofarted
Here's a link:
http://www.bannedcr500riders.com/board/ ... .php?t=410
And I have (1) coil adapter left over if you're interested.
Posted: June 7th, 2013, 8:56 pm
by Nodge
I think I have a set of motor mounts for a gen 1, and a couple coil adapters. I might have a set of case bushings, too.
Posted: June 8th, 2013, 5:49 am
by davidonmars
Nodge wrote:I think I have a set of motor mounts for a gen 1, and a couple coil adapters. I might have a set of case bushings, too.
I'd definitely be interested in the mounts I can't figure out how to pm you haha