Page 1 of 1

CR250 PIPE

Posted: April 5th, 2013, 2:28 pm
by brickmason
HEY THERE ARE SOME GUYS USING CR 250 PIPES TO CLEAR THE RADS ON THE 500 AF CONVERSIONS. MY PIPE SEEMS TO BE VERY CLOSE TO THE RADIATOR. 1992 CR500 ENGINE IN A 2006 CRF250R CHASSIS ANY IDEAS?

Posted: April 7th, 2013, 8:04 pm
by gregrobo
i would think not. the cr500 pipe fits perfectly with plenty of clearance whether it be fmf or pro cuircuit

Posted: April 8th, 2013, 9:34 am
by Roostius_Maximus
never a 250 pipe, not even maybe

Posted: April 11th, 2013, 7:54 am
by AlisoBob
Roostius_Maximus wrote:never a 250 pipe, not even maybe
x491

Posted: April 11th, 2013, 10:05 pm
by NightBiker07
Just curious, why would a 250 pipe not work? I havent set the pipes side by side, but from looking at them installed, the stinger outlet looks to be of similar diameter, and the beginning of the pipe also looks to be close in size. But, I am going going off a quick glance here

Posted: April 12th, 2013, 2:05 am
by jr475
Imagine eating authentic mexican food for ten days after getting five stiches in your asshole to close it up. It might work but the results are not desired. Shit needs the right flow (adn pulses)to make the motor run properly.

Posted: April 12th, 2013, 5:25 am
by Roostius_Maximus
Ever run a DG pipe? Same situation. It's way too small. My 87 had one. It'd idle, it'd snap the tire loose, it'd fall on its face at 4000rpm. If the pipe isn't scavenging the cyl there is a build up of spent gasses which will over come fresh fuel and it just won't run past that rpm.