Hi Guys,
I recently purchased an 87 CR500 and I am doing some work on it, she will not kick start but runs well when pull started, I have re-jetted for my altitude and added a Hot Wire coil, but still no luck kicking.. I picked up a new Ricky Stator ignition stator that they claim is the correct application for this bike, but it is not even close-the mount holes are off by 1/2 inch.. I believe the clearance is critical on the mount on this? Has anyone tried one of these or do you know of anyone making a stator that will fit? I think I got screwed on this stator, any help would be greatly appreciated!
Thanks guys,
Tom
Ricky Stator
-
NightBiker07
- Posts: 1942
- Joined: April 16th, 2008, 8:59 pm
- Location: USA
Pull starting but not kick starting is usually a sign of low compression.
2000 CR250, pipe, filter, Vforce
1980 XL80s
1969 Broncco TX-6
Natural selection favors Smart people, so nature selects morons to be slow and dumb for tigers and stuff too eat. But in our modern world there just aren't enough tigers.
1980 XL80s
1969 Broncco TX-6
Natural selection favors Smart people, so nature selects morons to be slow and dumb for tigers and stuff too eat. But in our modern world there just aren't enough tigers.