Urgent: need spec for C2 bushing outer diameter
Posted: February 2nd, 2013, 8:22 am
Hi guys.
I've got a 94 cr500 and I'm rebuilding the bottom end now.
Was checking all my gear and shaft diameters per service manual, and I found a big discrepancy.
I'm measuring 1.1807 on the C2 bushing od.
I checked this against our super mics for calibration and am 100% confident in this reading.
My service manual specs the c2 bushing od at 1.0622/1.0630
I called my local Honda dealer and their service manual matches mine, but they didn't have a manual for bikes older than 92.
Could someone please check their manual for a cr500 older than 92 and let me know what that spec is?
I have my cylinder out for bore/hone/new piston right now, and i NEED to let them know if the engine is not a 94.
Thank you!!!
I've got a 94 cr500 and I'm rebuilding the bottom end now.
Was checking all my gear and shaft diameters per service manual, and I found a big discrepancy.
I'm measuring 1.1807 on the C2 bushing od.
I checked this against our super mics for calibration and am 100% confident in this reading.
My service manual specs the c2 bushing od at 1.0622/1.0630
I called my local Honda dealer and their service manual matches mine, but they didn't have a manual for bikes older than 92.
Could someone please check their manual for a cr500 older than 92 and let me know what that spec is?
I have my cylinder out for bore/hone/new piston right now, and i NEED to let them know if the engine is not a 94.
Thank you!!!