Service Honda wiring: Help needed please
Posted: August 14th, 2012, 4:28 am
I am finally getting around to fitting the Service Honda ignition stator and wiring that I bought off a hoon on here, and I am in need of some guidance / clarification please.
I was hoping that someone out there with a genuine Service Honda with lights etc could take a close look at their bike and point me in the right direction on a couple of things.
In this first pic: A) There is a red connector block at the top of the pic, and I can't figure what it's supposed to connect to. (2 of it's 3 pins are associated with the engine kill switch on the handlebar switch block, no clues on the third pin !) B) There is a yellow wire with a red spot that runs along the harness (seen top right and bottom right of the pic) with bullet connectors. Any ideas what it's supposed to be for ? And finally, C) There is a black connector block (bottom left of pic) with a red/yellow trace wire, and a black wire into it. Any ideas what this one is for as well ?
In this pic, coming off the CDI (orange box), there is a black/white trace wire, and a green wire lead. This is normally the kill button connection, and I assume it is here too ? Now, that leaves the black/yellow trace wire, and green wire lead. This is the normal colour coding for the ignition coil wires, and again, I assume it is here too ? My question is, why are there 2 black/yellow trace wires in this lead ?Only one is needed for the ignition coil, so which one do I use, and what do I do with the other ?
In this third pic, there is a mystery pink wire and green wire. I am guessing they are a tail light feed, can anyone confirm this ?
Thanx in advance for any input.
I was hoping that someone out there with a genuine Service Honda with lights etc could take a close look at their bike and point me in the right direction on a couple of things.
In this first pic: A) There is a red connector block at the top of the pic, and I can't figure what it's supposed to connect to. (2 of it's 3 pins are associated with the engine kill switch on the handlebar switch block, no clues on the third pin !) B) There is a yellow wire with a red spot that runs along the harness (seen top right and bottom right of the pic) with bullet connectors. Any ideas what it's supposed to be for ? And finally, C) There is a black connector block (bottom left of pic) with a red/yellow trace wire, and a black wire into it. Any ideas what this one is for as well ?
In this pic, coming off the CDI (orange box), there is a black/white trace wire, and a green wire lead. This is normally the kill button connection, and I assume it is here too ? Now, that leaves the black/yellow trace wire, and green wire lead. This is the normal colour coding for the ignition coil wires, and again, I assume it is here too ? My question is, why are there 2 black/yellow trace wires in this lead ?Only one is needed for the ignition coil, so which one do I use, and what do I do with the other ?
In this third pic, there is a mystery pink wire and green wire. I am guessing they are a tail light feed, can anyone confirm this ?
Thanx in advance for any input.
