Im working on a gen 2 conversion and bought a Motion Pro seal driver. The shop I bought the driver from had two, the owner said they one of them was missed marked. He gave me the one he "thought" was the right one, but it is a little lose on the tube. I would guess about a 1-2mm lose. Is this right? Or should it be pretty close to a tight fit? The other one was about 1-2mm smaller. There both marked 46-47mm.
Any help would be appreciated. Thanks, Scott.
Help with a seal driver?
-
- Posts: 425
- Joined: July 31st, 2010, 5:22 am
- Location: Tillsonburg On
-
- Posts: 5
- Joined: January 7th, 2012, 4:13 pm