Page 1 of 1
V Force CR500
Posted: November 14th, 2007, 5:22 pm
by hagendog
If you read my post in the beer can section I now have some V Force reeds/cage for sale. I used these in my steel frame and made quite a difference but I don't belive they are going to fit in the new one. Still have the box for your shipping plessure. Paid $141 for these and would like to get $75 +shipping for them. I just had them all the way apart and there no crack or chips in the reeds.
Posted: November 28th, 2007, 9:36 am
by dannygraves
my vforces fit fine in my A/F
Posted: November 28th, 2007, 10:13 am
by hagendog
gen 3 with 88 motor and 5.4 spring, real tight. If I install the thing it makes getting the carb in almost impossible without removing the subframe. I had to install a reed cage and in boot off a later model to get to the point I am at now. Plus I don't have to cut the intake
Posted: November 28th, 2007, 10:16 am
by dannygraves
ah, ok. I pull my subframe to get the carb out every time anyway, but thats just me.
Posted: November 28th, 2007, 10:21 am
by hagendog
last time I rode this in the hills I had the carb out twice between rides, nice to just do it BUT I did like the way the v force felt in the steely. It's on ebay now but if no one gets it I will probally throw it on for shits and giggles
Posted: November 28th, 2007, 10:31 am
by britincali
The v-force definatly make a noticable difference from 0 to 1/2 throttle from then it feels about the same as stock.