Page 1 of 1
2006 crf 250/1997 cr500 ....any help would be great!
Posted: February 5th, 2012, 12:03 pm
by BBA
hello all I have stepped up to the plate and purchased a 2006 crf 250 rolling chassis I am going to put my 1997 motor in it . I have never done this in this is going to be all new any suggestions would be wonderful I would like to send the frame out to have it done so I have receipts anybody know anybody who does that and what the prices are?[/u]
Posted: February 5th, 2012, 12:51 pm
by Gmbond
Spend a few hours reading some posts, especially the sticky posts in the A/F section. Your questions are answered 1000xs over.
You have a gen4 read all you can about it.
Posted: February 10th, 2012, 10:02 pm
by BBA
thanks, i have. It looks like its a bit tougher to do but worth it when it comes to the handling? i just need to find a fab shop here in arizona to do it.
Posted: February 11th, 2012, 8:49 am
by AlisoBob
Oakdale is only a trip to UPS away....
Posted: February 11th, 2012, 3:23 pm
by BBA
I know what brown can do for me!
Posted: February 11th, 2012, 6:14 pm
by BBA
AlisoBob wrote:Oakdale is only a trip to UPS away....
how much do they charge? where are they located. I do want this done right. will be keeping this bike for a LONG time...
Posted: February 11th, 2012, 6:18 pm
by pstoffers
I'm in Oakdale Ca give me a call @ 209-480-7900 or pm me your # I'll call you
Paul
Posted: February 11th, 2012, 6:30 pm
by BBA
self portriat! late night glamis!
the bike i sold to buy the roller...box canyon AZ
Posted: February 11th, 2012, 6:33 pm
by BBA
the roller and the doner! 06 crf250r 97 cr500
Posted: February 11th, 2012, 6:35 pm
by BBA
Posted: February 11th, 2012, 11:14 pm
by asteroid500
welcome bud
Posted: February 12th, 2012, 6:51 am
by BBA
Thank you thank you. This place is like a library for CR500's......
Posted: February 12th, 2012, 7:02 am
by Roostius_Maximus
BBA wrote:Thank you thank you. This place is like a library for CR500's......
No, this is the hustler humor of cr500s and all that is good
