Page 1 of 1
gen 1 gen 2 stuff
Posted: August 31st, 2011, 1:07 pm
by kelroy_leon
hey, might have a gen 1 frame, shock, swingarm up for grabs. frame has tabs removed and part of x brace removed. gen 2 frame, forks, clamps, swingarm, shock, tank, subframe, seat. any interest?
Posted: August 31st, 2011, 2:27 pm
by Kuma
Prices?
Posted: September 8th, 2011, 6:03 am
by Fieldy109
What are you asking for on the Gen 1 frame?
Posted: September 9th, 2011, 7:09 pm
by Rue
What you asking for the swingarm, does it have any grooving where the chain slide is at (from wearing out the plastic guide and causing grooves on the swingarm itself). I bought one off e-bay and the guy said it didnt but it sure did!!
Swingarm
Posted: September 19th, 2011, 1:26 pm
by Westec Builder
I have 2 - 1989 roller bikes that have been stripped. Neither one had motors
Are you looking for a Gen 1 or Gen 2 swingarm
Posted: September 21st, 2011, 1:09 pm
by Kuma
Welcome Westec, didn't we do a ride together from the pilot forum at Dumont?
Posted: September 21st, 2011, 4:32 pm
by Westec Builder
That is correct! Your mental remembrance is still lucid. I am working on my friends 89 cr500 restore as we speak. I remember you warning me about the water pump cover corrosion on the early motors, WELL, thats what happened. I was trying to find info on that problem here. I need to know if the 94-on cover ( they still can be purchased) will fit on this 89 crank case. I know the part #'s are diff. but the only info I found was that the newer case is thicker for the newer clutch with more disks. Any thoughts? Doug
Posted: September 21st, 2011, 4:34 pm
by Kuma
I'm pretty sure the cover will work without any mods and if you want to put in a newer style clutch at some time you will already have the correct cover!
Posted: September 22nd, 2011, 7:05 am
by Westec Builder
thanks Kuma, will you be joining us at Dumont this Halloweeenee?
Posted: September 22nd, 2011, 7:57 am
by Kuma
Going to Glamis the weekend before, not sure if I'll make Dumont.