kind of funny. aparently glen posted it which makes it even funnier . bob you guys still fighting ?
Posted: August 23rd, 2011, 9:21 am
by AlisoBob
I havent talked to Glenn since he replaced my parts that he ruined with OEM Honda stuff.
One million dollars is how much he'd have to pay me to have a second try at my stuff.....
Posted: August 23rd, 2011, 10:46 am
by Rhino89523
He's over on the other side of town this morning, porting rants going in every direction from everyone.
Posted: August 23rd, 2011, 11:32 am
by AlisoBob
Dudes a hack, a whack, and a quack.....
Heres my 40 grit cylinder finish.... Clyde called in the "Cheese Grater"
Heres the piston STUCK IN THE BRAND NEW BORE!
"Bob,The hole in the back of the piston has to be there for the trail porting and being off center is ok, if the piston is stuck in the cylinder you should hone clear through but if the piston don't stick it's the coating,If you will notice the piston is stamped factory 89.94 mm on the top not 90.00mm, ,the piston was recoated after we ran on a short block with a electric mtr.,My helper james helps me,He said he ran the hone back through the ring area after the run of the cyl.to get a good cross hatch for the rings,,
The cyl. was bored with a torque plate and should work well on pump gas.The offset of the transfer intakes is on the flow bench that's how it flowed best.glen"
Old trees rot at the top.....
Posted: August 23rd, 2011, 12:35 pm
by Roostius_Maximus
you should have seen the look on bobs face when that piston didnt make it out the bottom
Posted: August 23rd, 2011, 12:44 pm
by AlisoBob
You should have seen the vein bulge in Roostys neck when he did push the piston through...
Posted: August 23rd, 2011, 12:50 pm
by Roostius_Maximus
hahahaha
Posted: August 23rd, 2011, 2:25 pm
by Joshwfl
Fucker stole my dollar, I made that thing years ago.
Posted: August 23rd, 2011, 5:14 pm
by 100hp honda
Rhino89523 wrote:He's over on the other side of town this morning, porting rants going in every direction from everyone.
was calling out anyone and everyone for a hillclimb challenge ?. old coot lost his marbles
Posted: August 24th, 2011, 8:24 am
by Rhino89523
I'm playing with him a bit....kind of fun.
Posted: August 25th, 2011, 6:14 pm
by 100hp honda
AlisoBob wrote:Dudes a hack, a whack, and a quack..........
and worlds best salesman. gauranteeeed he sold a few people beach front property in arizona
Posted: August 25th, 2011, 8:11 pm
by NightBiker07
100hp honda wrote:
AlisoBob wrote:Dudes a hack, a whack, and a quack..........
and worlds best salesman.
Apparently you have never used Oxy-clean.....LMAO!
