Page 1 of 1
Milling Machine
Posted: May 20th, 2011, 9:59 am
by maddog1927
Bridgeport Series 1 Variable Drive
Sony DRO
Full set of R8 collets plus holder
X axis power feed
Single shot lube system
6" Vise
8" Rotary table
Misc Tooling
Phase converter (Static)
$2500 Delivered Phoenix metro
Possible deliver to the Lakeside AZ area, maybe to LA area, depending on what trips I have coming up.
A nice addition to any shop.
Posted: May 20th, 2011, 11:40 am
by Roostius_Maximus
Posted: May 21st, 2011, 4:13 pm
by maddog1927
Roostius_Maximus wrote:
Adam, thanks for your condolences, but I am not getting out of the milling buisness, just doing something that makes my wife nervous, I amgoing for a newer model with tighter tolerances.
Old mill
New mill
Posted: May 21st, 2011, 6:36 pm
by Roostius_Maximus
sweet
Posted: May 21st, 2011, 6:46 pm
by Roostius_Maximus
thats pretty reasonable $ if that dro, vice, clamp set and rotary table come with
Posted: May 21st, 2011, 8:06 pm
by 100hp honda
if i was still in the area i would check it out. too far away now
Posted: May 29th, 2011, 6:42 pm
by roost251
Maddog, could you recomend any repair shops in AZ, I have a bridge port like yours(the one you are selling) and it needs new spindles bearings and a general going through. Thanks!
Posted: June 2nd, 2011, 5:47 pm
by maddog1927
roost251 wrote:Maddog, could you recomend any repair shops in AZ, I have a bridge port like yours(the one you are selling) and it needs new spindles bearings and a general going through. Thanks!
PM sent.
You could also call tom moore of moore tool and equipment. he seems to give good recomendations. He told me who to call to move the mill, and it worked out well
Posted: June 3rd, 2011, 10:39 pm
by roost251
Thanks again for the info, I lucked out on moving my mill to az as my friends had a fork lift and I have a good carhauler to put it on. Thanks.
Posted: June 8th, 2011, 8:48 am
by Roostius_Maximus
hey, I'm looking for something like this....
http://www.wttool.com/index/page/catego ... teChampion
my others are .200" shaft tip with a flat end, i'd prefer one the same, no ball end.
Any ideas on where to look?