Page 1 of 1
Exhaust hose?
Posted: February 17th, 2011, 5:46 pm
by AdmirableSoup
I am trying to find a tube/hose that will fit the gnarly pipe to its stinger. Got any ideas where i can find some?
Posted: February 17th, 2011, 6:06 pm
by iggys-amsoil
The Honda one works for me. Its a matter of it not sliding for or aft. I have a small L bracket clamped so it doesn't move either way.
Then if I need it. I made a wrap with aircraft hi temp sealant with graphite mess inside of it for strength. A couple of wraps and hose clamps.
Posted: February 17th, 2011, 6:21 pm
by 100hp honda
ya honda one does work the best i think. shouldnt be more than $20 shipped. cheaper way is some radiator hose.
if you get the honda one youll notice it has 3 grooves or maybe it was 2, i cant remeber right off. i know the cr250 has 3 grooves. i put a zip tie on both ends in the grooves and sometimes in the middle also. i been known to use rtv also but ive had them seal fine without it. rtv will be a hassle if you pull the silencer alot.
Posted: February 17th, 2011, 7:34 pm
by robfromga
I got a foot of diesel fuel line, from a semi at teh parts store for 10 bucks, 2 hoseclamps ands its been golden for 3 months now.
Posted: February 17th, 2011, 7:42 pm
by 100hp honda
definatly numerous ways to do it. once i used part of a old shock bladder. worked pretty good actually.
Posted: February 18th, 2011, 12:08 am
by AdmirableSoup
anyone got a part number? I don't even know what the damn things official name is...
Posted: February 18th, 2011, 3:59 am
by robfromga
I can cut you off a chunk and mail you a piece, pm me you address.
Posted: February 18th, 2011, 12:50 pm
by Crow500
AdmirableSoup wrote:anyone got a part number? I don't even know what the damn things official name is...
Service Honda. It is just called:
RUBBER
18365-KA5-740
Listed at $13.67
Posted: February 18th, 2011, 2:28 pm
by AdmirableSoup
PM sent your way rob.
And thanks crow for the part number. Always gotta have back up Rubbers
