Exhaust hose?

[AdmirableSoup]

I am trying to find a tube/hose that will fit the gnarly pipe to its stinger. Got any ideas where i can find some?

[iggys-amsoil]

The Honda one works for me. Its a matter of it not sliding for or aft. I have a small L bracket clamped so it doesn't move either way.

Then if I need it. I made a wrap with aircraft hi temp sealant with graphite mess inside of it for strength. A couple of wraps and hose clamps.

[100hp honda]

ya honda one does work the best i think. shouldnt be more than $20 shipped. cheaper way is some radiator hose.

if you get the honda one youll notice it has 3 grooves or maybe it was 2, i cant remeber right off. i know the cr250 has 3 grooves. i put a zip tie on both ends in the grooves and sometimes in the middle also. i been known to use rtv also but ive had them seal fine without it. rtv will be a hassle if you pull the silencer alot.

[robfromga]

I got a foot of diesel fuel line, from a semi at teh parts store for 10 bucks, 2 hoseclamps ands its been golden for 3 months now.

[100hp honda]

definatly numerous ways to do it. once i used part of a old shock bladder. worked pretty good actually.

[AdmirableSoup]

anyone got a part number? I don't even know what the damn things official name is...

[robfromga]

I can cut you off a chunk and mail you a piece, pm me you address.

[Crow500]

anyone got a part number? I don't even know what the damn things official name is...

Service Honda. It is just called:
RUBBER
18365-KA5-740
Listed at $13.67

[AdmirableSoup]

PM sent your way rob.

And thanks crow for the part number. Always gotta have back up Rubbers