BannedCR500Riders.com

I bought one a few months ago, and another today.
I had the same one for 10+ years i guess, and just needed another. the old one needs a bearing thats 1/2 the money of new.
I run a flow controll on it and keep it slow, carbides last longer, more controll, and the tool lasts.
CHEAP CHEAP CHEAP...

http://cgi.ebay.com/HP-5-EXTENDED-SHAFT ... 3cb2d8da6b

cool, i just need more money and time... damn these hobbies are expensive, especially if you have a few....

thanks Adam, will check it out....

I got 2 snap-ons like that cost bank!!!! The one I use the most just had the front bearing go out on the extension??? It was $24. For sweetish or $5. For china bearings went sweed!!!!!

What I do like about the snap-on is the exhaust port at the rear has a adjustable plastic piece that turn 360' and comes out at. 90' so you can turn the exh away from your ear and shoulder makes it kinda nice

all my mac and snapon shit has come and gone since i bought this grinder and it sees more action

Can't beat the price!!!
Was looking at some over at harbor freight almost got one to try it out but didn't