Dammn Good Die Grinder

http://www.youtube.com/user/500bigbore · December 22nd, 2010, 8:24 pm

I bought one a few months ago, and another today.
I had the same one for 10+ years i guess, and just needed another. the old one needs a bearing thats 1/2 the money of new.
I run a flow controll on it and keep it slow, carbides last longer, more controll, and the tool lasts.
CHEAP CHEAP CHEAP...

http://cgi.ebay.com/HP-5-EXTENDED-SHAFT ... 3cb2d8da6b

dubious01 · Post by **dubious01** » December 27th, 2010, 8:08 pm

cool, i just need more money and time... damn these hobbies are expensive, especially if you have a few....

thanks Adam, will check it out....

blownbillybob · Post by **blownbillybob** » January 19th, 2011, 12:07 pm

I got 2 snap-ons like that cost bank!!!! The one I use the most just had the front bearing go out on the extension??? It was $24. For sweetish or $5. For china bearings went sweed!!!!!

What I do like about the snap-on is the exhaust port at the rear has a adjustable plastic piece that turn 360' and comes out at. 90' so you can turn the exh away from your ear and shoulder makes it kinda nice

http://www.youtube.com/user/500bigbore · January 19th, 2011, 12:10 pm

all my mac and snapon shit has come and gone since i bought this grinder and it sees more action

blownbillybob · Post by **blownbillybob** » January 19th, 2011, 12:15 pm

Can't beat the price!!!
Was looking at some over at harbor freight almost got one to try it out but didn't

BannedCR500Riders.com

Dammn Good Die Grinder

Dammn Good Die Grinder