Page 1 of 1
swingarm extensions
Posted: October 10th, 2010, 7:46 pm
by 100hp honda
anybody got the capabilities if i provide the measurements ? the 550 desperatly needs some. looking to make a few changes on it this winter. got a dominator but need the extensions also. roasts the tire in 3rd from dead stop no prob
. should make a fine hillclimber.
Posted: October 11th, 2010, 1:32 pm
by Slomo
post the inside dimensions of the swingarm.
I have a nice set out of a KX500. If they will work, they will be cheaper than you can have a set made.
Posted: October 11th, 2010, 2:30 pm
by pstoffers
And if that don't work Call Pete Loomis at 406-690-3321
Posted: October 11th, 2010, 5:54 pm
by 100hp honda
no way kx extensions will work. ill get some pics to show why. also the end cap is welded in like the newer cr250. gonna need a setup like what lefty makes that bolt through the axle hole unless i grind the welds and pull the end caps out.
Posted: October 11th, 2010, 6:54 pm
by pstoffers
Or call Lefty 209-747-3640
Posted: October 11th, 2010, 9:49 pm
by 100hp honda
width is 1 1/8 outside measurement so no go on kx ones working. thnx for the help though slomas
. probly just call pete or lefty. i think pete ran a 550 back in the day so he probly already knows what i need or can point me in the right direction.
Posted: October 12th, 2010, 12:06 am
by pstoffers
I talked to Pete today. He said a 550 KTM wow yeah I can make some for him...... Give Pete a call.