BannedCR500Riders.com

i think the Uni's are heat-bonded, not glued. the material just seems to me "melted" together.

with the moose i use gas to clean, and wring it out real tight, then swing in a big circle for a minute, then oil it and no problems so far
completly off topic but roughly how many gallons of gas should my top end last?
im at 7 (+-1) pints of mix at 40:1 so im at 70 gallons should i be tearing it down and measuring?
i rarely keep it wound out and i keep the filter reasonably clean

2strokeforever wrote:with the moose i use gas to clean, and wring it out real tight, then swing in a big circle for a minute, then oil it and no problems so far
completly off topic but roughly how many gallons of gas should my top end last?
im at 7 (+-1) pints of mix at 40:1 so im at 70 gallons should i be tearing it down and measuring?
i rarely keep it wound out and i keep the filter reasonably clean

If you checked the compression before you ran the motor you would know when it starts to drop. That's how I know it's time for rings at least. I've read that when you get a 10% drop it's time for a rebuild. I generally do it before that much loss.

back on subject.

used twin air for 20 years, never had any issues, always cleaned with gas, once in the dirty gas bucket and then hit it in a clean gas bucket. Then soap and water. Belray was the diet for a long time, been having good luck with spectro oil which seems to be exactly like belray. If there is a better oil than belray it's not necessary.

filter skins rule. I haven't changed my filter in months, just skins. I haven't been riding as much as normal though. Finally got some dirt work to make some $$.

If you checked the compression before you ran the motor you would know when it starts to drop.

couldnt find a tester to borrow and was way too broke to buy one next time...

Hey boy's too sticky of an air filter oil will "dry" the cells,and let dirt pass right on thru.You need it to be slightly wet with a mild tactifier.Lucas oil stabilizer is for loose bearing clearences,not air filters,use what the manufacturer recommends. They engineered them that way.Chemical manufacturers don't make air filters.If you use a twin air,use their shit ,likewise K&N,Uni,No toil.Always oil both stages.If you are not sure, call the manfacturer! Be careful of No Toil, they use isopropyl alky in their oil,it will attack some filter's adhesives.Be careful.

No toil finally found something they make better than filters.

[/img]

Original No-Toil Gangster.....

Dude that is funny.

I hear that black guy is the janitor at the UNI factory.

Nice...

Compton Filter Oil

[youtube]http://www.youtube.com/watch?v=3BRw_ihZ ... re=related[/youtube]