Page 2 of 2
Posted: March 25th, 2011, 9:52 am
by teamdns
I love my magura as well and have not run into any situation where i miss my cable..... it did start to puke a little from the slave cylinder the last few rides but has never left me stuck.
i was able to pick up the new slave cylinder that has some updates. larger pull rod dust boot and one piece design.
WTB Hydraulic clutch conversion
Posted: April 15th, 2011, 2:50 am
by other
Hey Adam, Parts arrived today, thanks very much. Dust boot is a bit tired, can they be bought as a separate item, do you know ? I'll let you know how I get on once it's on and all bled up.
Cheers mate.
Greg
Posted: April 15th, 2011, 7:16 pm
by 2strokeforever
its a pain to get magura parts, but it can be done
use magura blood
bleed using bobs method, pop master cylinder off, uninstall slave from engine, remove gold cap, pop the piston out the , top master up so it dont run dry, hold slave vertical and when you see no bubles put piston back in
if theres no air in it it will have more throw than a cable