Getting stuff moved around in shop in prep for my frame to come back from Teem Trubble, I noticed that the carb off my donar '03 125 is a TMX Mik that (best I can tell) a 40mm carb with enough meet to broe out to MAYBE 42mm. I have taken the TM out to 42 before many times, but before I strip it down and chuck it up.........
Has anyone ran one of these on a hundy?
TIA
TMX Mikuni???
-
dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV
good carb, but only came in a 38mm, its a taper bore I believe, you have to measure as close to the slide as possible with a bore gauge. The part where the boot mounts should be like 43mm, I wouldn't cut too thin. it would run well with some jetting work as is though.
'09 kx450f 4-Poke
Gen-4 trail bike --SOLD--
Gen-3 badass trail/mx bike --SOLD--
Gen-1 built dunes bike --SOLD--
'05 klx110 --SOLD--
'95 pw80
Gen-4 trail bike --SOLD--
Gen-3 badass trail/mx bike --SOLD--
Gen-1 built dunes bike --SOLD--
'05 klx110 --SOLD--
'95 pw80