Thanks guys, at least some people can appreciate it. I was over the moon with the outcome but when when the factory boys were checking this out at Finke and giving the thumbs up that really made my day.
Ended up with a few bits just because I could. I really like the graphics being tasteful IMO , so these are some of the bolt on bits
Talon hubs / stainless spokes / excel rims with tubliss system
ASV levers / pro taper bars and venhill cables
Scott's sub mount damper and rear disk gaurd
PWK 39
Billet engine covers (eBay seller mrmike from England)
Light speed frame gaurds, rear calliper gaurd
Steg pegz
Graphics by mx graphics (USA)
Seat bump stop by guts
Clarke oversize tank
Hammerhead levers
Galfer oversize front disk
IMS pegs with acerbis covers
FMF pipes / boysen RAD valve
The motor was rebuilt basically stock bottom end with top end having reworked head and cylinder lightly reworked.
Suspension done by GDR (Greenfield desert racing in Alice Springs) for my weight. For any Aussies out there, Stephen was an ex Finke winner quite a few times on cr500's and will listen and give you suspension aimed at your skill level, not the same shit they just pump out for everyone at the better known shops. The only advertising he does is by word of mouth and the fork leg stickers you see on the top off road racers around, including Toby price. Always super helpfull and great turn around times.
1 more Aussie 09' 450R
- Gravel Scratcher
- Posts: 278
- Joined: September 20th, 2009, 8:45 pm
- Location: Australia, Central QLD
- Gravel Scratcher
- Posts: 278
- Joined: September 20th, 2009, 8:45 pm
- Location: Australia, Central QLD
- Gravel Scratcher
- Posts: 278
- Joined: September 20th, 2009, 8:45 pm
- Location: Australia, Central QLD