1985 Engine - 1997 Frame - Rear Bushings
1985 Engine - 1997 Frame - Rear Bushings
I have a roller I built from a 1997 CR500 frame. I just purchased a 1985 engine. I know you can replace the rear bushings to accomodate to the larger swingarm bolt or bore the bushing. What is the easiest approach? What has people had the best results with? I am thinking I may have to have the new bushing made unless I can obtain a 1989+ bushing on here.
Steelie Build Done
Gen 1 CR500 AF Complete - SOLD
Gen 1 CR500 AF Complete - SOLD
- Roostius_Maximus
- Site Admin
- Posts: 4641
- Joined: November 16th, 2007, 3:24 pm
- Location: Mt Nebo, Manitoba, Canada
- Contact:
the bushing in there if its an 85 theres a sleeve only, 86-88 has the small bushing.
the 85 had washers beside the case.
Make them as a 1 piece deal.
Need measurements?
the 85 had washers beside the case.
Make them as a 1 piece deal.
Need measurements?
http://www.youtube.com/user/500bigbore
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
Bushings
Yes this would be fantastic thanks.Roostius_Maximus wrote:the bushing in there if its an 85 theres a sleeve only, 86-88 has the small bushing.
the 85 had washers beside the case.
Make them as a 1 piece deal.
Need measurements?
Steelie Build Done
Gen 1 CR500 AF Complete - SOLD
Gen 1 CR500 AF Complete - SOLD
Bushing
Will I need to bore the cases? How hard is it to remove this sleeve?Roostius_Maximus wrote:the bushing in there if its an 85 theres a sleeve only, 86-88 has the small bushing.
the 85 had washers beside the case.
Make them as a 1 piece deal.
Need measurements?
Steelie Build Done
Gen 1 CR500 AF Complete - SOLD
Gen 1 CR500 AF Complete - SOLD