BannedCR500Riders.com

Here is another 500 top end on a Honda Pilot, he had a problem with the piston breaking between the ring grooves on the intake side. here is the link to the pilot forum, I noted that the oil holes were not drilled for the exhaust bridge, would that have caused the failure? http://www.pilotodyssey.co...

OK, I know preheat is needed, how much? is there a temperature to pre-heat to, I can use an inferred temperature readout just need to know where to go.

I have a scotts mounted on my '01, I think it was an option that came from SH, it mounts to the bar clamps if I recall correctly.

90 or newer will be your best all around choice, no water pump issues with the larger clutch and you don't have to plumb the water to the cylinder odd.
just my

Damm, that is big, doesn't even fit on my monitor
Sounds like a smoking deal, almost wish I needed it

Very nice, are you going to run that on the ice also or is it just a summer toy?

I've seen that one before, go to all that trouble to make the custom pipes, why not lay it down horizontal so you could use it in something other than a boat? for that matter, with the snowmobile pipe tech, they could have cut the number of pipes in half, or just get rid of them and supercharge or t...

nice looking bike, now go get some mud on it!

like the bike and the truck!

how much for the swingarm?

nice job and less than a month to complete.

That's awesome, are you planning to do it again or now that you have done that you move on to other things?
Congrats on a great accomplishment that not too many people have done!

I'll reply but I'm no expert just what I understand from the sites: stock PJ38, I still run it but I run mainly dunes, I have no complaints but then again I am just in an ignorant bliss. 39.5 PKW, this is the carb that seems to be the best all around, Eric Gore claims it adds 3 HP to the top end and...

very nice, I wish moto GP still ran the 2 stroke 500s

Should be fine, just plan to get a new clutch side case housing the water pump, they can still be had for around $200

Thanks Bob, and Thanks Adam!

ya just can't trust them canuks

there is no link to the ebay listing? seller's name, and the photos have been removed?

Roostie's done lots of work for hoons on both sites and I can't recall ever seeing any complaints about his work.

Hey Hey, welcome over, I have no idea what my bike runs at, it typically self adjusts the coolant level once filled, no over flow bottle but without a thermostat inline I would think cruising on flat ground is deffinatly going to be cooler than pulling a sand dune, if it all seems good I'd just keep...

Just focus on keeping the rubber side down!

keep your eyes open and see what's out there, I have heard that some have bought complete bikes and were able to part out the engine, electrics and what ever else not needed along with parting the doner bike you it is possible to end up paying next to nothing. this could just be one of those urban l...

I didn't see this link on the post but this seems like a it belongs here
http://www.bannedcr500riders.com/board/ ... sc&start=0

Just thought I'd but a link onto this thread to another tank mood thread, hope ya don't mind Bob.
http://www.bannedcr500riders.com/board/ ... php?t=6441

I have not heard of that being done but sounds like a good idea, you should do a separate build thread just on that mod, make sure to add a link to your thread onto this one.