BannedCR500Riders.com

I think i get what you are saying but would like to see it before i start drilling. thank you also been doin this for a while and forgot to mention it, JB weld a carb vent tube to the gold cap and route it up over the headstay andd back down, keeps dirt out and theres no air trapped above the piston...

Auto correct is something else. I wonder when computers rule and run everything will they auto correct themselves?? lol

It was meant to say shoot them an email.

Hoof, shoot this guys animal they are very helpful. The beauty of the Gatos mount is that it IS NOT bike specific. where the mount accepts the bar mounts it has 4 cams. the cams rotate so they adjust to fit ANY BIKE. these guys are good.its a little pricey but worth it. I also bought their bar ends....

If any of you are looking for some very nicely made stabilizer mounts, check out Gatos Bros. i looked for a month until i finally found something better than the big clunky mounts from scotts and everyone else.
Lotta work can wait to RIDE!!

[img[/img]

also been doin this for a while and forgot to mention it, JB weld a carb vent tube to the gold cap and route it up over the headstay andd back down, keeps dirt out and theres no air trapped above the piston it makes a noticeable diffrence, with the 9mm, this, bearing lever, and moly paste lubed eve...

you get this leak when the seal is disturbed due to being pulled too far out or pushed too far in. you have to remove the cap and push the actuator in and pull it out a few times to reset the seal, this worked for mine.
the magura instructions explain this issue pretty well.

take a look at this link i included below. the most sensible way i have seen it explained is called, staging, i believe. It really helped with one bike i just couldn't get right. they recommend going full soft on both ends so you know exactly what that feels like, then working your way to to stiffer...

Good to be here! Have heard what a good board this place is, look forward to making friends and learning about my 500. I have an 09 CRF450 frame, 93 CR500 engine beast. Decent when i got it but needed some serious attention to detail. I've added a few things and its getting close. Thanks for having ...