Search found 71 matches
- January 25th, 2008, 11:39 pm
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
ok will do,thereis a couple of degrees of wagle from left to right on big end,could this be my vibration problem .there doesnt seem to be any movement up or down on big or little end.allso there is some scortching on underside of piston what is the cause of this? allso noticed two small recesses on ...
- January 25th, 2008, 2:09 am
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
- January 24th, 2008, 11:27 pm
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
- January 24th, 2008, 12:27 pm
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
- January 24th, 2008, 7:25 am
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
hi guys engines out ,frames gone to powder coaters and gathering parts.took barell off and isnt so bad think she needs rebore and piston. some burn marks on exhaust port sides,and slight marks not scoring,burn marks on piston ,cross hatching(think thats what you call it) seems non existant.allso som...
- January 23rd, 2008, 12:55 am
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
yep i was hoping there would be another fix for this problem ,and didnt really want to spend a lot on engine .not to worry come to conclusion need to split engine and spend extra cash to get her right plannin full nut and bolt resto should look suberb when done will keep you posted.thanks for the ad...
- January 22nd, 2008, 7:47 am
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
- January 22nd, 2008, 5:59 am
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
- January 22nd, 2008, 3:37 am
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
got her back today and mechanic was right,she vibrates when you rev her and fuel comes out of overflow due to worn nedlle and float i think,she doesnt vibrate at all on tick over and no fuel overflow.he reckons the worn carb parts could be due to the vibration,theres no wines rattles or anything lik...
- January 21st, 2008, 4:16 am
- Forum: Drive Tech
- Topic: vibration
- Replies: 48
- Views: 1330
vibration
when idling she runs ok but when you open throttle she vibrates quit a bit.my mechanic said this has caused the float to wear on the pin and cause some overflow out of choke mechanism when reved hard,main bearings seem fine,rings were bit rusty and stuck in piston so he said ,any ideas?.will remove ...
- January 20th, 2008, 10:09 am
- Forum: Drive Tech
- Topic: engine question
- Replies: 6
- Views: 266
- January 13th, 2008, 9:57 am
- Forum: Drive Tech
- Topic: case saver
- Replies: 21
- Views: 632
- January 11th, 2008, 11:31 am
- Forum: Drive Tech
- Topic: cr 500 wont start
- Replies: 18
- Views: 404
- January 11th, 2008, 6:13 am
- Forum: Shoppers Only!
- Topic: wanted
- Replies: 7
- Views: 627
- January 11th, 2008, 6:10 am
- Forum: Drive Tech
- Topic: cr 500 wont start
- Replies: 18
- Views: 404
- January 10th, 2008, 1:05 pm
- Forum: Shoppers Only!
- Topic: wanted
- Replies: 7
- Views: 627
- January 9th, 2008, 1:09 pm
- Forum: Shoppers Only!
- Topic: wanted
- Replies: 7
- Views: 627
wanted
looking for honda racing ignition cover for 89 cr 500
- January 9th, 2008, 12:33 pm
- Forum: Drive Tech
- Topic: cr 500 wont start
- Replies: 18
- Views: 404
- January 9th, 2008, 12:27 pm
- Forum: Drive Tech
- Topic: cr 500 wont start
- Replies: 18
- Views: 404
point taken guys i was in a bit if a rush.she doesnt seem to smoke really bad but has been standing for some time i think.I hav checked everything,such as reeds,cleaned carb and blown through with air line,checked all electrical componants,new plug ,fresh fuel.when i did get her going it was with fu...
- January 9th, 2008, 9:58 am
- Forum: Drive Tech
- Topic: cr 500 wont start
- Replies: 18
- Views: 404
- January 9th, 2008, 1:13 am
- Forum: Drive Tech
- Topic: cr 500 wont start
- Replies: 18
- Views: 404
cr 500 wont start
right had this 89 few weeks now she ran fine then all of sudden wont start ,she will bump but will only run on choke even then she stalls sometimes when she is running engines sweet when going goes like a train splutters low down a little ,so i cleaned carb set carb to factory settings air mix /chok...