Search found 53 matches

by wastedyouth02
February 14th, 2015, 7:16 pm
Forum: Drive Tech
Topic: jetting advice
Replies: 7
Views: 1320

So I checked my reeds and lo and behold the top reeds were stock honda and bottom were the after markets....got those swapped out for a new set of the "super stock" fiber glass reeds and bike seems to run a bit cleaner now but i still have the original issue. Ive reread the jetting stickys...
by wastedyouth02
February 1st, 2015, 9:42 am
Forum: Drive Tech
Topic: jetting advice
Replies: 7
Views: 1320

jetting advice

I have a '91 500 with some jetting issues. The bike wont idle to start and I believe it is too rich from off idle to ~1/8-1/4 throttle. after about 1/4 the bike feels good up to the top but I do have real bad vibrations from 3/4 on, bad enough that at wfo I can hold onto the bars, I know these beast...
by wastedyouth02
October 26th, 2012, 5:31 pm
Forum: Shoppers Only!
Topic: NEED 500 Gas tank
Replies: 2
Views: 480

NEED 500 Gas tank

Anyone in the socal area have a gas tank theyd like to get rid of?
by wastedyouth02
December 17th, 2011, 8:18 am
Forum: A/F's Only.... Talk About Your Beer Can, Right Friggin HERE!
Topic: Gen 1 conversion options?
Replies: 5
Views: 371

I had two bikes at once, one got parted out and i ended up with one title....dont remember which was which now. Almost positive its a 89 though.
by wastedyouth02
December 17th, 2011, 3:14 am
Forum: A/F's Only.... Talk About Your Beer Can, Right Friggin HERE!
Topic: Gen 1 conversion options?
Replies: 5
Views: 371

Looking at my signature... maybe i have a 91.....now i got my self confused, ill have to double check when i get back from the stan.
by wastedyouth02
December 17th, 2011, 2:54 am
Forum: A/F's Only.... Talk About Your Beer Can, Right Friggin HERE!
Topic: Gen 1 conversion options?
Replies: 5
Views: 371

Gen 1 conversion options?

So the plan is to get a gen 1 cr250 ride it for awhile (Ive had the bug for a light MXer for awhile) then swap the motor out of the 500 into the 250. All the write-ups and shan's drawings make it look to easy but i have a couple questions. Will my 89 motor work fine in the gen 1 frame with the drawi...
by wastedyouth02
December 15th, 2010, 3:19 pm
Forum: Drive Tech
Topic: Another jetting thread
Replies: 18
Views: 923

Thanks to all for the feed back. I stepped down to a 48 and a 165 and it got ALOT better stepped down to a 45 and 160 and now the thing frekkin flys. Gonna wait for my new airscrew assembly to show up and ill start fine tuning some more so itll hopefully idle
by wastedyouth02
December 15th, 2010, 7:38 am
Forum: B.S. Stories, True Stories... Its All Here
Topic: 50 plus group?
Replies: 13
Views: 1123

Ill have to try thoose, I use a pair of my oakley sunglasses with the darkest tint availible underneath some tinted gogles and it works alrite.
by wastedyouth02
December 14th, 2010, 8:10 pm
Forum: B.S. Stories, True Stories... Its All Here
Topic: 50 plus group?
Replies: 13
Views: 1123

Im 21 and have retinitispigmintosa or however u spell it, and the same stuff happens to me just drivin down the road plus shaded spots are black and once i go into the shade the non shaded parts are bright bright white, shit sucks tryin to ride forest stuff sometimes.
by wastedyouth02
December 14th, 2010, 7:55 pm
Forum: Drive Tech
Topic: Another jetting thread
Replies: 18
Views: 923

Yea that video was today and were still in the mid 70s high, and i havent riden it due to the lack of it runing. Tomorrow ill go get a 165 and down another pilot and see what happens
by wastedyouth02
December 14th, 2010, 7:01 pm
Forum: Upcoming Rides
Topic: HoonFEST 2011!!!
Replies: 102
Views: 26373

Im in, Whats north pheonix area? Im about an hour from the 111 in PHX
by wastedyouth02
December 14th, 2010, 6:40 pm
Forum: Drive Tech
Topic: Another jetting thread
Replies: 18
Views: 923

yea the idle adjustment nor choke setting effects its idle, is that a good indication that my pilot is still too rich? And yes im at 5000ft.
by wastedyouth02
December 14th, 2010, 6:22 pm
Forum: Drive Tech
Topic: Another jetting thread
Replies: 18
Views: 923

So i went the wrong way with the main, i believed it was lean. I see the spec for the float level but whats that measurement to.
by wastedyouth02
December 14th, 2010, 5:02 pm
Forum: Drive Tech
Topic: Another jetting thread
Replies: 18
Views: 923

Ok so: Started with god knows what i couldnt read the jets, no idle top end falls on its face Picked up a 58 slow 170 main, was told this was stock as i didnt have a manual at the time. Same results as before no idle top end falls on face choke has no change air screw gives no change Got a manual an...
by wastedyouth02
November 21st, 2010, 6:53 pm
Forum: Drive Tech
Topic: Another jetting thread
Replies: 18
Views: 923

I cleaned it once and put it back, and it acted the same. So i pulled it again cleaned it normally with the can and straw then took air to it then carb dip then air again, im 99% sure its completely clean.
by wastedyouth02
November 21st, 2010, 6:36 pm
Forum: Drive Tech
Topic: Another jetting thread
Replies: 18
Views: 923

Another jetting thread

So i bought my 500 back from my friend for $200 after he tore the bike down and got it all powder coated :D. He said he couldn't get it to start, the ground wire on the coil was disconnected. So now it starts but does not idle, holding the throttle just slightly open it stays running, then pulls alr...
by wastedyouth02
February 6th, 2009, 7:46 am
Forum: Shoppers Only!
Topic: Alota parts for sale San Diego
Replies: 6
Views: 847

I got a rear and a 18inch(i think) front left. the front has a tire mounted to it and holds air and all that 15$, let me get a pic of the rear for you because some of the chrome is startin to flake in the center section
by wastedyouth02
February 5th, 2009, 9:18 pm
Forum: Shoppers Only!
Topic: Alota parts for sale San Diego
Replies: 6
Views: 847

Alota parts for sale San Diego

Hey all i have pretty much a bike and a half minus motors. I travel alot for work so i dont have alot of time to ship stuff, so im trying to sell everytihng local that i can first. Just tell me what you want ill see what i got and itll all go real cheap, i got a jeep so thats another money pit i nee...
by wastedyouth02
September 30th, 2008, 6:53 pm
Forum: Shoppers Only!
Topic: wanted motor
Replies: 1
Views: 297

wanted motor

anyone got a decent motor they wanna sell? i realized how much i miss my 500 and then realized i have neough parts to build one minus forks motor electronics and carb. i have a 89 frame do the 89+ motors all swap
by wastedyouth02
April 20th, 2008, 4:20 pm
Forum: B.S. Stories, True Stories... Its All Here
Topic: Started building my track today
Replies: 19
Views: 1325

Im deffenetley gonna have to stop by the next time im out htere then
by wastedyouth02
April 17th, 2008, 9:39 pm
Forum: Drive Tech
Topic: Looking to get a bike, got some ?'s and stuff.
Replies: 15
Views: 339

I had a 07 450x went out to the desert a couple times with it then rode a friends 500 and sold the 450 as soon as i got back..been loving it ever since, only one thing i dont like abiut it is the vibration sometimes starts to really mess with my hands
by wastedyouth02
April 17th, 2008, 9:35 pm
Forum: B.S. Stories, True Stories... Its All Here
Topic: Conservative or liberal?
Replies: 51
Views: 3002

SO this girl took the fun part out of sex to then intentionally add the (most of the time) unwanted by product of sex to just then throw it away...god these people make no sense
by wastedyouth02
April 17th, 2008, 9:11 pm
Forum: Suspension Tech
Topic: suspension work
Replies: 22
Views: 1994

i would if it had a motor sorry i basically got everything minus motor and electronics and plastic stuff
by wastedyouth02
April 17th, 2008, 1:40 pm
Forum: Suspension Tech
Topic: suspension work
Replies: 22
Views: 1994

no..i got it realllly cheap