BannedCR500Riders.com

Nobody?? Where is Adam he has everything. Lol

Anyone got a cr250 frame that could make an engine jig. I already have a crf150r with a crf250r engine. Now I wanta put a cr250 engine in a 150r frame. I need to build the frame first due to money reasons. Lol I hope everyone is good since I haven't been in here In a bit. I have been out tearing aro...

SOld

its for a 2001. or 89-01 all should be the same. price drop 500 shipped

nobody?

Everything is new oem. Bolts, studs, nuts, gasket kit ,cylinder, head, piston, rings, bearing and wrist pin. 550 shipped

well here she is straight from AJ's garage.

shit man!!! Your doner was a conversion!!!!

Today is the day!! Gonna be a longs ass work day

not the same one but DAMM CLOSE

An elf told me that cr500 Santa is gonna swing by the house tomorrow. I have no cookies to leave out so I left a cold miller and a full bong!!

http://i277.photobucket.com/albums/kk68/04yamahar1/cyl8.jpg http://i277.photobucket.com/albums/kk68/04yamahar1/cyl7.jpg http://i277.photobucket.com/albums/kk68/04yamahar1/cyl6.jpg http://i277.photobucket.com/albums/kk68/04yamahar1/cyl5.jpg http://i277.photobucket.com/albums/kk68/04yamahar1/cyl4.jpg...

Neither catapiller looking port is larger thane the gasket. It's just the "wings" are farther down than fastkarts. Actually they are gone

Nope the port has been dremeled on intake side. Adam pointed it out in 3 seconds

i ordered this from a honda dealership and it came all packaged up from the factory. but what is going on here?

Nobody??

so if ya ordered a new cylinder and oem piston and rings what are the steps needed to make it right? ring gap .02 correct. do ya need to hone the cylinder to get proper piston to cylinder clearence or does it come ready to go from honda?

A tight bottom end motor. Let the jokes begin. Butt (haha) seriously looking for a bottom end motor[/quote]

Well once again AJ has treated my like a friend and let me tell ya that says something because I have never had the pleasure of meeting him yet. Pics of the new hotrod to come.

I can guarentee they are no way associated with mugen. I think they are just calling it that cause of the graphics

I was talking about the builders.

thanks bob. every 2 years? i was thinking every year. haha shows how much i know.

if you bought a new cylinder, piston, rings and changed the rings often and kept them within specs would you ever have to bore. also when you get a new piston and rings what is the proper procedure to check ring gap? thanks homies

Nasty in a good way