BannedCR500Riders.com

looking for a bottom end for a cr500 please call or text me at 4165710306. need the tranny and the clutch parts and gears really. I have a crank and cases

Hey guys my cr500 that I put together last year has a bad miss on the top end. Got all the ignition parts off roostius stator flywheel cdi coil. Has a 180 main I have just been tweaking this bike fixing other issues now I have to tackle this one. Tried br8es and bpr8es new cap swapped coils and plug...

How much for the rad? Text 4165710306

Hey guys I'm kind of confused here. I got my two swingarm sleeves ready to go 53 and 56mm. Which one goes on the kicker side and which is the sprocket side. The instructions show longer on sprocket side but then was looking through pictures and saw a few people use the smaller spacer on the sprocket...

Does the 53mm one go on the sprocket or kicker side?

He ported my 4mm banshee and im grinning from ear to ear. Just got back a blaster cylinder from him so will see how that goes

looking if anyone is interested in trading there wide ratio trans for a close ratio. thanks

take the case bushings out and have them put in a lathe and opened up some. that way you can always throw another set in to run in older chassis

that helped thanks. so 4 and 6mm then? the drawings show 4 and 7mm. I just want to make sure this is right.

I have read everything over and over but I get conflicting answers, hence why I am making this post.

i was wold instead of using the spacers i could run a 02+ cr125 swingarm bushings and washers i just wanted to confirm

so doing a Gen 1. For the swinger bushings to properly center the motor the 02+ cr125 bushings and collars/washers properly centre the motor correct? 54 and 59mm right?

will these work on gen1's

welcome im from just north of toronto

That's what I thought from reading too but my af swinger bolt doesn't fit in the bushings

Have the engine here. The number on it is PE02E 5702892. Tried putting my 98 cr250 swinger bolt through it and it's too big the bolt. Thanks for the help.

i have a 98 cr250 frame and swinger but found a 98 cr125 with blown bearings i still need the forks, shock, rad, seat, rims , tires. Will this all fit on the 98 cr250 frame? is the gen 1 cr250 and cr125 frame the same?

Nodge wrote:I think I have a set of motor mounts for a gen 1, and a couple coil adapters. I might have a set of case bushings, too.

I'd definitely be interested in the mounts I can't figure out how to pm you haha

Just picked up a gen 1 and want to do the conversion. motor will be a 93 I read somewhere but cant recall where that there is a honda bushing and spacer that is the correct size and I dont have to mess around with washers or anything? Anyone confirm this for me or have some part numbers. Also does a...